• 示例幻灯片1

如何取出装回塑料粉碎机筛网架

关注:564 发表时间:2016-08-13 14:05:06

1.打开筛网架及筛网。Open the screen frame and screen

1)松开筛网架固定用的2个把手螺母D。

Loosen the 2 handle nuts“D"used to fix the screen frame.

集中粉碎机centralized granulator


2)用手扶住筛网架往下到适当高度后往前拉出。

Hold the screen frame down to the appropriate height and pull it out.


3)将筛网从筛网架上取出。

Remove the screen from the screen frame.


   

2.安装回机器部件Re-install the machine parts


2. 1)装回筛网架及筛网

Re-install the screen and screen frame

1)将筛网放在筛网架上,对准筛网两端的定位槽与筛网架上的止位筋。

Put the screen on the screen frame, both ends of the screen should be directed at the positioning rib between the positioning groove and screen frame.

2)移动筛网架后部的挂钩进入切削室后部的定位槽中。

Move the hook on the back of the screen frame to the positioning groove in the cutting chamber.

3)旋转筛网架沿上,直到与切削室完全靠住。

Rotate the screen frame upwards until it completely leans against the cutting chamber.

4)拧紧把手螺母D。

Screw down the star-shaped handle D.

5)将料仓装回到筛网架底部的槽中。

Place the feed bin into the groove on the bottom of the screen frame.

6)筛网架部分完全装好。

Screen frame is completely installed.


2.2)装回上箱 Re-install the charging barrel

1)朝前扶住上箱直到与切削室闭合。

Hold the charging barrel forward until it completely fits the cutting chamber. 

注:请用手扶住上箱直到闭合,防止自由跌落造成损坏。

Note: Use hands to hold the charging barrel until it completely closed to avoid damage caused by free drop.


2.3)装回外壳  Re-install case

1)如果机器带外壳装置。

If the machine has case.

2)将外壳对准料筒边沿往里推进。

Pull the case inward along the edge of the charging barrel.

3)直到插销进入插孔内

Until the bolt enters into the jack

4)外壳安装到位。

Case installation completed.


在线咨询

您好,请点击在线客服进行在线沟通!

点击这里给我发消息QQ
点击这里给我发消息QQ
联系方式
13967152218
咨询热线
15988838812
咨询热线
扫一扫二维码
二维码 二维码