每三个月的保养检查
Maintenance And Inspection Every Three Months
请检查各保护装置的功能。万一机器不能正常运转,请马上停止运转并与本公司取得联系。倘若在保护装置出现故障时运转将会引起事故,所以请绝对避免。
Please check all the function of the protection device. Once machine cannot operate properly, please stop immediately and get in touch with our company. If the protection device fails, may cause accidents, so please pay special attention to.
保养项目 Maintenance | 操作内容 Operation Content |
马达用的 热继电器 跳闸功能 Tripping | 请进行试运行 Please do pilot run 打开电磁启动器,边用安培测定器量电流值, 边按下图用十字螺丝刀将热继电器电流 值设定按钮按顺时针方向旋转,将设定值慢 慢地降低。
Turn on the electromagnetic starter, use ampere meter to measure the current of caliber, and clockwise rotate the thermal relay current setting button with Philip,s head screw, and lower the setting value slowly.
确认热继电器是否跳闸。(跳闸会停止运转)确认后请将热继电器回复到原先的设定 值后,按下热继电器的复位开关。对于电气 知识不十分了解的人,很容易造成故障和危 险,请不要擅自处理,检查操作请委托弊社。 Confirm whether thermal relay tripping. (It will stop running at tripping), please reset thermal relay back to the original Settings, press the reset switch of thermal relay. Personnel lack of electrical knowledge may easy to cause trouble and danger, do not handle without authorization, please entrust our company to check the operation.
|
保养限位 开 关 Maintenance of limit switch
| 关闭电源 Switch off the power supply 取下料斗、上体 Remove the hopper and upper side 消除限位开关部的尘埃 Clean the dust in limit switch 限位开关盖变形时,请及时更换 Please replace the limit switch cover if it is deformed |